Product |
|
A high performance two pack aliphatic isocyanate cured polyurethane coating, containing heat, light fast & chemical resistant pigments & extenders to provide tough & highly durable non yellowing coating with excellent gloss and color retention properties. The product is extremely versatile & can be used as excellent protective as well as decorating. |
Recommended Use |
|
Bright and non-yellowing over prolonged exposure. Very high gloss with extremely high surface hardness. Suitable over any surface with equal efficiency. Applicable by brush, roller & spray. When used in combination with suitable primer it can provide ten years protection of the surface Area of use: Interior and exterior. • On steel surfaces, machinery, tanks, pipes, gypsum, block work, brick work, etc. |
Specification & Other Information |
||||||||||||||||||||
|
Surface Preparation |
|
All surfaces to be coated should be clean, absolutely dry and oil or moisture free before painting application. Oil and grease should be removed by solvent cleaning. Repair Cases: Corroded areas should be cleaned with power tool to St3 or blast cleaned to Sa2 or better. Existing system should be dry and free from loose paint, salt, grease and other contaminants prior to coating. New steel: Abrasive blasting to Sa 2½ (ISO 8501-1:2007). For temporary protection, if required, use a suitable primer. All damage of primer and contamination from storage and fabrication should be thoroughly cleaned prior to final painting. Maintenance: Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Clean damaged areas thoroughly by power tool cleaning to St 3 (ISO 8501-1:2007) (minor areas) or by abrasive blasting to min. Sa 2, preferably to Sa 2½ (ISO 8501-1:2007). Improved surface preparation will improve the performance of the product. Stainless steel: To be abrasive blast cleaned to a uniform, sharp, dense profile (ISO Comparator Medium (G), corresponding to Rz minimum 50 micron. Any salts, grease, oil, etc. to be removed before abrasive blasting. |
Application Data |
||||||||||||||||||
Working Precautions: Material should not be allowed to remain in pipeline, hoses, gun or spray equipment. Thoroughly flush all equipment with Mypoxy thinner. Maintenance: Clean all equipment immediately after use with Mypoxy thinner. It is good working practice to periodically flush out spray equipment during the course of the working day. All surplus materials and empty containers should be disposed off in accordance with appropriate regional legal regulations. |
Drying Characteristics |
|||||||||
|
Compatibility |
|||||
|
Storage |
|
This is solvent based coating and the containers should be tightly closed and should be kept in a cool, dry, well ventilated space and away from any source of heat and ignition. |
Caution |
|
This product is for professional use only. The paint applicators should be trained and experienced professionals with right equipments to mix and apply the coatings correctly as instructed. Applicators should use appropriate protective gear while using this product. This is a solvent based product and should be use under well ventilated conditions. Nose and mouth shall be covered. Skin contact should be avoided. In case of spillage on the skin, it should immediately be removed with suitable cleanser, soap and water. Eyes should be washed with water thoroughly. |
Limitation of Liability |
|
This information is given to the best of our knowledge. Because of the multitude of formulations, production, and application conditions, all the above-mentioned statements have to be adjusted to the circumstances of the processor. Our products are often used under conditions beyond MSPL's control. MSPL cannot guarantee anything but the quality of the product itself. No liabilities can be derived from this fact for individual cases. This issue replaces all previous versions – Printed in India. |